Home> News> Large Format Sublimation Printer- What Should We Do When It Stops Working?

Large Format Sublimation Printer- What Should We Do When It Stops Working?

Sometimes we may suddenly encounter the problem that the large format sublimation printers stop working. The problem wastes printing material and causes coat losses.Even if a person is very crippled, it may also happen

Actually, the solutions to this problem of sublimation digital printer are very sample. In order to solve this problem, I specially asked our company's printer technical engineer today, so let me explain the specific situation to you all.

Roland large format sublimation printer

When a sublimation inkjer printer suddenly stopped working, it's ususlly for the following reasons:

1. Static electricity effect. Check to see if your ground wire meets the standard. A standard-compliant ground wire is a necessary for wide format printers.

2. Many times the data cable connected to the computer will also cause the print to stagnate.

In this case, it is usually necessary to re-plug the data cable. If it still doesn't work, you can go to the mall to buy the same print line and try it.

3. The most likely cause of this problem is that the computer main board settings are incorrect.

Roland large format sublimation printer

The job of the printer is to have a requirement for the computer configuration. If the computer configuration is too low or does not match the applicable model on the printer instructions, then of course it is prone to printing problems, and may not even work at all.

4, if the above methods have been tried or not, then you have to change the mainboard and memory of digital printer. As a last resort, try not to use it. First, check the above problems step by step, and then make sure that there is no problem, then replace the mainboard and memory. Or simply ask the repair master to help you solve the problem.

Actually, the solutions to this problem of sublimation digital printer are very sample. In order to solve this problem, I specially asked our company's printer technical engineer today, so let me explain the specific situation to you all.