Home> News> Digital Sublimation Textile Printer Heating System Daily Using Tips

Digital Sublimation Textile Printer Heating System Daily Using Tips

When the climate is cold, the computing device output screen of the digital sublimation textile printer is hard to dry out, and even the image sample spreads, so many customers are troubled by means of how to use the heating function of the computer well. In fact, the use of the heater depends mainly on the ambient temperature and humidity. The most beneficial working environment temperature of the computing device is 18℃~ 25℃, humidity about 70%, for buddies who do now not have general air conditioning and humidifier installation, I will comply with the season, Environmental conditions describe the use of a variety of desktop heaters: 

digital sublimation textile printer

Sublimation Printer

The desktop for sublimation printers in the room is outfitted with no heating device. It wishes to buy an exterior heater. The manufacturing unit has an optional arc-shaped infrared heater. The heater of fabric printer is heated evenly and has low efficiency. It is appropriate for single-head machines. The heater is turned on 10 minutes before the drawing, and the heating temperature is set at 50℃ to 55℃. When the temperature exceeds 55℃, many materials are baked and deformed, causing the film to fail.

The double-head computer is recommended to purchase an external medium-wave tube heater in addition to the infrared heater to improve the drying efficiency. The medium wave tube heater is a knob type adjusting drying effectivity device, and it is endorsed to amplify the drying energy as a good deal as possible except baking the deformed material. 

digital sublimation textile printer

Outdoor Printer

The digital inkjet printer is geared up with heating and pre-heating. The external heater desires to be bought separately. The manufacturing facility has an optionally available arc-shaped infrared heater. The heater is heated evenly and has low efficiency. It is appropriate for single-head machines. It is recommended that the heater be became on 10 minutes before the drawing, and the heating temperature setting: the medium heating placing temperature is lower than 30℃. If the temperature is too high, the nozzle will be wiped off due to immoderate softness of the material or the paper will not move. Before heating 45℃ ~ 55℃; infrared heater 50℃ ~ 55℃, greater than 55℃, many substances will be baked and deformed, ensuing in printing failure.